Your step-by-step guide:
The hole position on the spine of lever-arch files may differ between manufacturers, thus some trimming
of your Design-A-File labels may be required.
DO YOU NEED TO TRIM?
Align the hole of your Design-A-File label with the hole on the lever arch file. If the label extends over any edge
of the spine of the file, trimming will be required.
HOW TO TRIM:
1. On the back of the label, mark where the label extends over the edge.
2. Trim the label 1mm shorter than this line for a perfect fit.
TO APPLY THE LABEL
1. First remove only the two pieces of backing paper around the hole. (To easily remove the backing
paper, bend the label slightly on the score line.)
2. Position the label onto the spine of the file, around the hole, and stick that part to the spine.
3. Working outwards from the hole, remove the next piece of backing paper and stick the label to the file until the whole label is applied.
